Management of air tool / oil pulse tool |
●Torque Tester DI-4B-25 |
For Daily Torque measurement of a small impact Tool, |
Specification | DI-4B-25 | |||
Measuring range | 0.30~25 N・m 3.0~250 kgf・cm 3.0~220 lbf・in | |||
Operative Measuring Range at P-D Mode | 0.70 - 25 N.m 7.0 - 250 kgf.cm 7.0 - 220 lbf.in | |||
Accuracy | ± 0.5% (in case of reading 499 or less = last digit +/- 3 reading) | |||
Display | Torque Meter | LED Digital Display, 4 digits | ||
Blow Counter | LED Digital Display, 2 digits (Displayed only in P-P mode) | |||
Measureing Direction | CW, CCW selectable with a Switch | |||
M''ment Mode | P-P Peak | Holding Peak Load Value | ||
T-R Track | Showing Real time torque value ( Used for Zero-Adjustment ) | |||
P-D Peak down | Holding Load Value at the moment to change from upward to downword | |||
Blow Counter | Count Range | Zero to 99 blow | ||
Count Time | 0.1 - 9.9 seconds | |||
Automatic Clearance | Automatically clear the displayed value after certain time (0.5 - 3.0 sec,selectable at each 0.5 sec). Setting 0.0 sec for manual Zero clearance | |||
One-touch-Zero Clearance | Easy Zero-Adjustment with pressing CLEAR button | |||
Data output | Serial Interface RS232C (Baud rate: 9600) | |||
Power Supply | Battery | Ni-Cd Chargeable Battery 1.2V x 5 cells (700mAh) | ||
Automatic PW off | Automatically power off after 5 minutes left without operation | |||
Charging time | Within 6 hours | |||
Continunous working time | 8 hours | |||
Battery Life Time | Chargeable more than 300 times | |||
Weight | 2.1kg | |||
Dimension | 150(W) x220(D) x74 (H) | |||
Accessories | Bit Socket ( 6.35 HEX - Subtense 17mm ) | |||
Measuring Joint : Hard Type (M10) & Soft Type (M10) | ||||
Socket for Wrenches ( Subtense 17mm ) | ||||
Dedicated AC/DC Adaptor (Charger), 230VAC or 120VAC- DC 7.5V 120mA Output | ||||
Exclusive receipt case | ||||
An inspection report, a proofreading certificate, traceability system figure |
Attachment About the method of application of an attachment | |
Soft joint Subtense 17mm This is a joint to reproduce the state to fasten a screw actually. It is designed to make about 3 turns before reaching max. torque (torque to be measured) after Nut or Bolt reaches to the surface of the fastened objects. For elastic body. | |
Hard joint Subtense 17mm This is a joint to reproduce the state to fasten a screw actually. It is designed to make about 1/10 turns before reaching max. torque (torque to be measured) after Nut or Bolt reaches to the surface of the fastened objects. |