該閥廣泛應用于建材、冶金、礦山、電力，化工、玻璃、輕工、糧食等行業，是控制流量、調節或切斷粉塵物料的理想設備。

  The valve is widely used in the building material, metallurgy, mining, electric power chemical, glass, light industry and food industry etc. It is the ideal equipment to control flow, adjust or cut down powder material.

結構特點：

Structure characteristic:

  密閉性強、操作靈活、傳動部分無污染、無粉塵影響、使用壽命長、無泄漏、安裝不受角度影響，能隨時開閉，調節物料流量，特別適用于無粘度的固體粉料及小于Φ10mm的顆粒料、晶體料、固狀料的輸送及流量調節。

  This valve is good in seal, handy to open and closing, long life and not leaky. There is no contamination and dust influence in driving part. It can be installed at any angle. It also can be opened and closed at any time to change the flow of material. It is especially suitable for non-glutinosity solid powder and crystalloid, grain, solid material to be transported.

性能參數

Performance parameter

適用溫度                           公稱壓力                                                  適用介質

Suitable temperature            Nominal pressure                       Suitable medium

≤120℃                             0.05MPa                               空氣、粉塵氣體、固體粉料、晶體料

                                                                                Air, gas with dust, solid powder, crystalloid

外形圖：

Appearance figure:

外形連接尺寸：

Appearance joint dimension:

工作原理：

Working principle

  主要由框架、閘板、絲桿、螺母等零件構成，用手轉動手輪使絲桿帶著絲桿螺母和閘板沿水平方向往復運動，達到閘門的啟閉目的。

  It is mainly made up of frame, gate board, screw pole, nut etc. Rotate the handwheel by hand, then the screw pole drives the nut and gate board move in horizontal to and fro to open or close the valve.

使用說明：

Usage explanation:

l  本閥可水平安裝或垂直安裝，安裝時兩法蘭連接中間必須加密封墊片，然后鎖緊螺栓。

l  操作時手輪順時針旋轉為閥關，反之為開，不得在手輪上再增加輔助杠桿。

l  若長期存放應使設備處于關閉狀態，各傳動部位應加潤滑油，不允許露天存放或堆置。

l  It can be installed in horizontal or vertical. Sealing gasket must be put on the connected, then equably tight the bolt.

l  You can not add assistant lever to the hａnd wheel. Clockwise turn of hａnd wheel means the closing of valve, otherwise it means opening.

l  The device should be in the shut-down if the valve-board is placed longer. Driving parts should add lubricated oil. Placing in the open air and piling up is not permitted. 

訂貨須知:

Information for order

l 選用訂貨時，請參照產品樣本注明產品規格、型號及技術參數（使用溫度、設備工況、介質性質等）。

l 表格中未列規格、用于特殊介質或其它特殊要求，請與我公司經銷部、技術部聯系，可為您另行設計、制造。

l Please indicate the type, model and technical parameter (using temperature, working condition of equipment and characteristic of medium etc) referring to the product sample when you place an order.

l If you have other special demand, need special medium or the spec that is not listed in the table, please contact with our department of market and technology. We can design and manufacture for you especially.

地址：中國湖北荊州市沙市區十號路98號   Add: No.98, No 10 Road Shashi District Jingzhou HuheiChina

郵編(Postcode)：434006   傳真(Fax)：  電話(Tel)：0716--4310982