EE046冷凝報警器有助于防止冷凝梁和其他關鍵冷點上的冷凝，并適用于安裝在平面和直徑為50毫米（2 "）的管道上.
當物體表面周圍的空氣相對濕度（RH）達到99%RH時，表面會發生冷凝. 依靠與表面非常好的熱耦合，EE046可精確測量表面溫度下的空氣相對濕度.
在冷凝實際發生之前，繼電器輸出會在接近冷凝條件時發出預警. 該產品還會提示電源故障或電纜損壞. 狀態LED燈指示正常運行，冷凝危險或電源故障.E+E涂層保護濕度敏感元件免受灰塵和污染物影響.
Key Features
- 可靠的監測冷凝危險
- 快速響應時間
- E+E鍍膜保護防止灰塵污染
- 緊湊型設計方便安裝
- LED狀態指示
典型應用
- 冷凍梁
- 開關柜
- 環境控制
技術資料
-
10...99% RH
工作范圍 -
90 ±3% RH
開關節點 -
t90 < 3 min.
表面溫度變化響應時間 -
t90 < 25 sec.
相對濕度變化響應時間 -
24 V AC/DC, 1 A
開關負載 -
24 V AC/DC
供電
EE046 condensation monitor is used for detecting the danger of condensation on pipes, ducts and other surfaces before condensation actually occurs.
The device measures the relative humidity at the surface to be monitored and provides an early warning signal (relay) when the humidity reaches 90% RH.
The signal can be used for initiating control steps such as increasing the water temperature in a chilled ceiling, reducing the cooling capacity or switching on the heating.A special coating protects electronics and sensor against contamination.
Key Features
- Early detection of condensation danger
- High accuracy and long term stability
- Compact design
- Fast response time
- Sensor protection
- Easy mounting and wiring
- LED status indication
Typical Applications
- Chilled ceilings
- HVAC, buliding automation
- Rectifier cabinets for wind power generatiors
- Switching and electronics cabinets
