綜合測試項目 | Test items | 綜合測試項目 | Comprehensive Test items | |
1、平均效率測試 | CEC test | 28、短路測試 | Short circuit test | |
2、定電壓模式的電流測量 | DC Current under C.V.Mode | 29、短路電流測試 | Short circuit current | |
3、峰對峰值噪聲 | Peak-Peak noise | 30、過電壓保護 | OV protection | |
4、反應時間測試 | Serial reaction time test | 31、低電壓保護 | UV protection | |
5、瞬態反應時間 | Transient response time | 32、超載保護 | OL protection | |
6、瞬態電壓 | Transient spike | 33、過功率保護 | OP protection | |
7、輸出電壓順序 | Tracking | 34、測試中調整測試 | In-test adjustment test | |
8、電壓穩定度 | Voltage regulation | 35、輸入斷電測試 | AC cycle drop out | |
9、電流穩定度 | Current regulation | 36、輸入電源失真模擬 | PLD simulation | |
10、開機時序 | Turn ON time | 37、直流輸出電流 | DC output current test | |
11、上升時間 | Rise time | 38、直流輸出電壓 | DC output voltage test | |
12、下降時間 | Fall time | 39、波形讀取測試 | Waveform read test | |
13、關機時間 | Hold-up time | 40、輸入沖擊電流測試 | Input impulse current test | |
14、浪涌電流測試 | Inrush current test | 41、輸入功率 | Input power | |
15、電源"好"信號(PG) | Power good signal | 42、繼電器控制 | Relay control | |
16、電源失效信號(PF) | Power fail signal | 43、條形碼讀取 | Bar code scan | |
17、開啟電源供應器信號 | P/S ON signal | 44、動態測試 | Dynamic test | |
18、輸出上升波形 | Power up sequence | 45、定功率模式下的特性測量 | Specification under C.P.Mode | |
19、輸出下降波形 | Power off sequence | 46、輸入峰值電流測試 | Input Peak current | |
20、效率測試 | Effciency test | 47、額外擴充量測測試 | Additional expansion measurement test | |
21、整體穩定性測試 | Overall stability test | 48、輸入有效值電流 | Input RMS current | |
22、風扇速度測試 | Fan Speed test | 49、TTL信號控制 | TTL signal control | |
23、輸入功率因數 | Input power factor | 48、Lan 讀/寫 | LAN read/write | |
24、輸入電壓緩升/降測試 | Input voltage ramp | 51、RS485讀/寫 | RS485 read/write | |
25、輸入頻率緩升/降測試 | Input freq. ramp | 52、USB讀/寫 | USB read/write | |
26、擴充量測測試 | Extend the measurement test | 53、232讀/寫 | 232 read/write | |
27、自動調整測試 | Automatic test | 54、GPIB讀/寫 | GPIB read/write |